Crown XTi 6000 Power Amplifier

2 ohm Stereo (per channel): 3,000W
4 ohm Stereo (per channel): 2,100W
8 ohm Stereo (per channel) 1,200W
4 ohm Bridge-Mono 6,000W
8 ohm Bridge-Mono 4,200W
Integrated speaker presets with LCD front panel display
Accurate, uncolored sound with very low distortion for the best in music and voice reproduction
Advanced protection circuitry
Extremely versatile, handling a wide range of speaker impedances and outputs
Switch-mode universal power supply
Speaker presets for crossover frequencies, EQ, limiting, and delay
Speakon and binding post outputs, XLR inputs and loop-thrus
Comprehensive LED status per channel
Three-Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications
Sensitivity (volts RMS) for full rated power at 4 ohms: 1.4V
Frequency Response (at 1 watt into 4 ohms, 20Hz - 20 kHz): +0/-1 dB
Signal to Noise Ratio (below rated 1kHz power at 8 ohms), A-weighted: 103dB
Damping Factor (8 ohm): 20 Hz to 400 Hz: > 500
Input stage: Input is electronically balanced and employs precision 1 percent resistors.
AC Line Current (120VAC amplifier playing 1/8 power pink noise into 4 ohms per ch): 15.3A; at idle draws no more than 180 watts
Crosstalk (below rated power) 20Hz to 1kHz: > 70 dB
Input impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced
Load impedance (note: safe with all types of loads): Stereo - 2-8 ohms; Bridge mono - 4-16 ohms
Voltage Gain (at 1 kHz, 8 ohm rated output): 37.1 dB
Maximum Input Signal: +22 dBu typical
Operating Temperature: 0 degrees C to 40 degrees C at 95 percent relative humidity (non-condensing)
AC Line Voltage and Frequency Configurations Available (+/- 10%): 100V, 120V, 220-240V 50/60 Hz
Ventilation : Flow-through ventilation from front to back
Cooling: Heat sinks and proportional-speed fan
Dimensions: Width, Height, Depth (behind mounting surface)
EIA Standard 19" W x 3.5 in" H x 16.2 in D
Net Weight: 24 lbs.
Shipping Weight: 30 lbs.